The introduction of plucker machine

Plucker, also known as automatic plucker machine, used for poultry after death chickens, ducks, geese, cats, dogs,sheep, rabbits and so on.It can be a one-time off the plush feather, fine hair, claws and their epidermal fouling, and its working principle and for the ginger skin, de-potato skin, off scales and other agricultural products peeled skin machine works the same, so that people working relieved from the dirty and tiring manual labor, it greatly improves work efficiency.

Plucker machine usage:

1, check out the various parts out of the box, as in the transport caused by loose screws, to re-reinforcement, hand swivel the chassis to see if it is flexible, or to adjust the rotating belt.

2, put the position of the machine to determine later, in the side of the machine installed a knife switch or cable switch.

3, when the slaughter of chickens and ducks, the knife as small as possible to kill some slaughter, chickens and ducks should be placed in warm water (about 30 degrees) after slaughtering, so that the body feathers warm, it is best to put some salt in warm water to avoid Epidermis damaged when hair.

4, the temperature of the chickens and ducks placed in about 75 degrees hot water, and stir with a stick, so that the whole body hot uniform.

5, the hot chicken into the machine, put a 1-5 can be.

6, put a knife switch, the machine starts, while running, while poultry who add water, preferably hot water, plump feathers, dirt along with the water out, the water can be recycled, a minute to do all the feathers, In addition to the net body epidermis dirt.

Precautions:

1, ground wire installed leakage switch;

2, plug in the power before use, turn on the switch to check whether the turntable is operating normally.

3, after use, the hair removal bucket rinse clean.

4, Long-term use of rubber wool wand wear or fracture, should be promptly replaced, in order to ensure the normal hair removal efficiency.

5, in the use of a period of time, if you find turntable speed slow, you may slip belt shaft, should tighten the nut base, and be careful not to be too tight.

Remember: can not be directly sprayed pipe cleaning.

Pre：How to maintain the machine when not in use for a long time

Next： Frequently Asked Questions and Solutions Of Layer Cages